These nails will not rust even with exposure to the elements.
Cedar lap siding installation blind nailing.
Lap siding can be installed horizontally or vertically.
Read and understand all pages of the installation instructions before starting the siding application.
These have small ridges on the sides to prevent the nail from pulling out of the siding after installation.
Siding up to 6 inches wide can be blind nailed with one siding nail per bearing toe nailed through the base of each tongue.
Do not nail through overlaps.
Choose stainless steel ring shank siding nails or hot dipped galvanized siding nails.
Allow a 1 8 inch expansion gap between pieces if the siding is air or kiln dried.
Installation instructions for standard lap and self aligning lap siding 7 16 in.
In those areas where an air space between siding and sheathing is desired nail siding to furring strips table 4.
All old mill widths cedar shake lap and smooth lap 1 2 in.
Old mill and cedar shake lap important.
Place nail just above the overlap.
Siding shall be installed with top blind nailing with the nails placed 3 8 inch 10 mm from either end and a minimum of 3 4 inch 19 mm from the top edge of the board.
This is particularly important for vertical installation.
The nail gun you use for siding will have to be able to handle siding nails.
On center when bevel sidings 11 16 or thinner are applied without sheathing.
Use an air nailer if possible to speed nailing and minimize damage to siding surface from hammer dents.
Wider siding should be face nailed using two nails per piece.
Take care not to nail through the overlap of two pieces.
Bevel siding should be face nailed to studs with 1 1 4 inch penetration into solid wood using one nail per piece spaced at a maximum of 24 inches on center.
In vertical application start at one corner with grooved edge toward the adjacent wall.
Ensure joints meet on studs blocking or furring strips with the nail penetrating solid wood at least 1 1 4 inches.
Nails must penetrate 1 1 4 inches into solid wood.
For horizontal applications start with the bottom course and work up with the channels pointing upwards.
