Cedar Siding Nails On The Top Or Bottom

Attach the siding with 10d galvanized box nails driven into the overlap at least 1 2 in.

Cedar siding nails on the top or bottom.

Fasten a cedar starter strip the same thickness as the top of the beveled siding all around the house using a tape measure and level to set it level along the bottom of the wall. If you have insulated sheathing predrill the nail holes to avoid crushing the insulation. The courses should overlap by at least 1 in. Whether you install clapboard t1 11 cedar shakes or board and batten siding on your house you can attach it with either nails or screws.

More product details close. Where possible the bottom of the board that is placed across the top of the windows should coincide with the window cap. A diyer or a novice painter might attempt to achieve a cleaner look by caulking the siding nails but the nail is guaranteed to push the caulking material out within a few months. 7d galvanized siding nails the grip rite 2 1 4 in.

Many builders choose nails because they re easier to. Place nail just above the overlap. Replace siding by working from the bottom up you might need a helper here. Above the bottom edge.

The nails holding up the siding should not be caulked. Normally you nail either the top of the siding or the bottom of the siding but not both. Nailing at the top. Bevel siding should be face nailed to studs with 1 1 4 inch penetration into solid wood using one nail per piece spaced at a maximum of 24 inches on center.

I actually prefer nailing the siding boards at the bottom specifically because it holds the lap siding in much better than blind nailing i e. Siding nails should not be caulked another item that needs room to play is siding boards themselves. The siding does not move at all with nails in the bottom of the board as you have effectively nailed the board at the bottom and top once the nails go in the bottom of the next. 7d galvanized siding nails 1 lb pack have a spiral shank designed to help drive the nails into hard woods.

The main reason for nailing the top of the board is to hide the fasteners but nailing the tops leaves the bottoms a little loose giving bugs possible entry points.